Drilling into the working joint

DRILLING INTO THE WALL


„Drill Above floor” zacznij wiercić tyle nad posadzką

Drilling angle [°]
„Drill Hole Angle “- Drill at this angle towards the joint

Drill depth [cm]
„DRILL DEPTH” –for such a distance you need to make a hole to drill into the contact, remember to deepen the hole so as to pierce the contact (we suggest +2cm)

DRILLING INTO THE FLOOR

MOVE AWAY FROM THE WALL [cm]
„Move away from the wall” – start drilling by this amount of cm

Drill hole angle [°]
„Drill hole angle ” – Drill at this angle towards the joint

Drill depth [cm]
„Drill depth” – for such a distance you need to make a hole to drill into the contact, remember to deepen the hole so as to pierce the contact (we suggest +2cm)

Place so large a packer [cm]
„Place so large a packer” – Insert the injection packer to such a length into the well so that the rubber can properly anchor. Remember to choose the right length of the packer so that you can tighten it and connect the injection cap (“Place so large a packer + min 3 cm)